My fan was supplied with bullet type connects but I wanted to use the original connector so the pins were removed from the old connector of the fan photo 31.jpg You should end up with the below, a separate plastic bit and two spade terminals photo 32.jpg These were cut from the fan and the end opene...

Two brackets 65mm x 30mm were bent to provide top mounting these were welded inside the top to the u-section flush with the top Note: these could be pop riveted or bolted along the top photo 21.jpg The radiator was again reassembled and test fitted and holes marked for drilling with 8mm drill bit as...

Test fit radiator photo 11.jpg And bottom bracket photo 12.jpg In my case the following measurements resulted for the bottom bracket photo 13.jpg *see further on for how the 20mm was found photo 14.jpg photo 15.jpg Two 8mm holes were drilled in the bottom bracket and it fitted to the vehicle using t...

ALL INFORMATION IN THIS BUILD IS PROVIDED AS INFORMATION ONLY :!: I AM NOT RESPONSIBLE FOR HOW THIS INFORMATION IS USED AND ANY OPINIONS STATED ARE THAT OF THE AUTHOR.*Unless otherwise stated, all images and written content copyright of author. Any unauthorized reproduction, copying, duplication, pl...

This site would be worth contacting https://www.bmsmotor.com/wire_diagram.html

The manual is available here http://www.teammightyboy.com/workshop/39-tech-info/71-mightyboy-manual  see the bottom of the home page http://www.teammightyboy.com/

That "Chip" is a reed switch its closed by the magnet mounted on the disc that rotates with the speed o so if you put a resistance meter across it and turn the input to the speed o it will show the resistance changing from zero to infinity -check the auto manual page 21-11 and 21-62 .Its o...

Email sent if you haven't seen it you may want to check the junk

check this Starters

If this
"Tonneau cover #3 - Over bar, press stud & channel style. Never fitted, dirty from storage - $60"
 Is still available consider it sold . PM to payment + arrange post RF.

Just had my front window replaced with a new one rubber had to be imported but window was off the shelf

Hope this is clear Tez

Great work Tez!

I would just grind a bit off the roll pin (and re chamfer the end) this is mearly a locating device so it does not need to be solid .

As per BUSBOY a 125cc suzuki motorcycle engine is about 62mm bore you can get these from china for about $20-$40 each with rings ; i dont know the other dimensions which would need to be checked (pin diameter, pin center to top of piston etc...see link below for an exmaple that has dimensions) but t...