ok i was off this for a while but today i had a quick look at it again, i have now got the electronic ignition running great with the old coil and resistor set up, i did however find i had a fuel leak. The screws holding down the top bit of the carburator were lose so the fuel was coming out of the ...

ok in the end i used the old coil with the resistor
ill see if i can get the su12 to work latter.
what is the advantage to the su12?
or will my old coil burn out eventualy ?

I have a little thing on my earth cable could that be an issue?
Not sure whatnot is . Looks like a capacitor or somthing?

i got a su12 exactly like in the link, but it wont fire with it on,
i mean it sparks at the plugs but the engine just cranks like theres nothing
old coil back on and it fires again, su12 back on and still nothing...
blody cars eh

no wories went to another one and got a SU12
Putting it on now
thanks

The guy didn't know what a su12 coil was/is
Will a gt40 coil be ok? I'm sure I remember somone talking about that being ok to use.

ok thanks mate
so ill pop into supercheap and get a su12 coil tomorow.
is that what i ask for ? a SU12 coil ?

C80R so i guess its suposed to use a resistor?
it dose run now with the kit on and this c80r coil with resistor removed, but will it last ?

I have a two pin coil on it just now is that the wrong coil then? It's had it on for two years now haha
So can I just use the two pin coil already on the car for the conversion just without the resistors?

So I read the DIY guide and orderd up a crane came xr700
But when I went to look over it my coil set up seems to be in a mess.
Like I have 2 ballast resistors and some other stuff going on. Can I remove all this and replace with a su12 coil and just one of the resistors?
See pic

hey buddy thanks for that, but i got it sorted so no need any more, thanks thoe

would you post the auto box to WA?
any ideas on cost ?

no I mean the differential.
im struggeling to find an auto box and I think its just the differential that's gone on mine (admitedly I have not took box apart to find that out)
so I wonderd if I could get a manual box and change diffs over.

I don't want to hi jack but dose anyone know if the diffs are also interchangeable from auto to manual?

ok so i did a wet comptession test with same results so im guessing botom end is ok just head.
removed the head and the exhaust valve on cylinder 1 was burnt out,
head is away getting a full rebuild and an extra deep skim to raise compression a bit more while im at it,
would be rude not to eh.