Hi Guys, in the process of installing a rpm gauge, just wonder where do i hook up the rpm signal wire to on a f10A?

Can anyone confirm these are the correct tie rods I'm after? http://m.ebay.com.au/itm/4x-Inner-Outer-Tie-Rod-End-SUZUKI-CARRY-ST80-SV90-SK408-4CYL-797cc-1979-1992-/151787571990?nav=SEARCH For the pitman arm bush, I couldn't find any. Maybe is cheaper option to change on both side. Is there different...

Sorry I didn't mention I had try on another set of wheels, these current tyres and new wheels has no lumps and rotated the wheels. It still vibrate intermittent around 60km/hr. Where else should I be looking at?

Hi Guys, Im getting crazy steering wobble when reach the speed between 55-65km/hr, it will shake violently and felt like the front wheels about to come off :roll: Not sure is this a common issue with the st90 and would like to get this sorted out... I've a vid of it when its happening https://vid.me...

You still have the sc kit or it is sold?

I've opt for the amr300, bought a near complete kit for the f10a come with crank pulley, attached tensioner and blow thru carby. I think I will stick with draw thru setup.



Any idea what v ribbed belt to use and where to run the belt from?

Do you know which direction the sc rotor is spinning. I heard if it spin clockwise/counter clockwise, you may need to find out which is the correct air inlet and outlet.

What diameter is the piping? Look tight fit!

I see there's three brackets supporting the sc. The top bracket act as a tensioner for the belt? What belt would be using?

Thanks Murray. Are you using the mini 1.5" SU carb? Any adv/disadv using a ARM500 over Eaton M45. I wonder what happened to monometalico SC f10a. Here are some of his posts re sc with an eaton m45, im so tempted to go SC aswell :) : http://www.suzuki-forums.com/suzuki-carry-every-forum/18512-su...

Hi Guys, Can you please assist/recommend what to use for ST90 ute F10A with drums front and rear, I don't think the previous owner has done fluid changes/maintenance. So far I can think of these, unless I have miss out something... Brake fluid: any dot4 fluid? Engine Oil: Oil Filter: Ryco Z125 Spark...

Thanks all, its a F10A.

Hi Murray, your amr500 sc is going into what engine?

Wae.

How can you identify your engine is a f8a or f10a? I bought my 1984 carry st90 ute, seller said it was 1.0L but then vin no show 0.8l

murryinc wrote:I am currently working on a amr500 setup for my f10a carry. I guess a 1.5 su is the go. Anyone no best way to deal with timing

Do you have any current pictures for the amr500 setup.

Long shot here, does anyone know/ have updates re to his supercharge carry f10a?