Hi all
I am having some gearbox troubles my mighty boy will sometimes shift from 2nd to 3rd easily but sometimes you have to wiggle it around before it goes into gear. i think it might be the gear selector mechanism for 3rd and 4th gear that is worn out inside the gearbox or a syncro
Thanks
Search found 83 matches
- Wed Jun 01, 2016 9:58 pm
- Forum: Suzuki MightyBoy
- Topic: Shifting Problems
- Replies: 2
- Views: 664
- Fri May 27, 2016 3:22 pm
- Forum: Suzuki MightyBoy
- Topic: Carby differnce
- Replies: 4
- Views: 993
Re: Carby differnce
Would it be worth it to just swap over the jets and pilot jets instead of spending 110 bucks in a rebuild kit?
- Thu May 26, 2016 10:47 am
- Forum: Suzuki MightyBoy
- Topic: Carby differnce
- Replies: 4
- Views: 993
Carby differnce
Hi all, a while ago when i previously purchased my new mighty boy it had a shagged carby (f8b carb) so i put my f5a carb on it will this reduce power?.
Thanks
Thanks
- Tue May 24, 2016 8:31 pm
- Forum: Suzuki MightyBoy
- Topic: Speedo differnce
- Replies: 0
- Views: 3527
Speedo differnce
hi guys i took the mightyboy for its second test drive today and the speedo was only reading about 85 but it felt like atleast 100, does the f8b gearbox have a different speedo gear rotational speed to the mightyboy gearbox making it read a lower speed?
Thanks
Thanks
- Fri May 20, 2016 8:59 pm
- Forum: Suzuki MightyBoy
- Topic: Gearbox inspection plate screws
- Replies: 1
- Views: 556
Gearbox inspection plate screws
So previously i managed to snap 3 screws of the 5 that held the inspection plate on for the gearbox i then attempted to remove them causing more damage. i have since taken it to an engineering shop and they could only remove 2 of the 3 with the 3rd being to broken to remove i am wondering if it is s...
- Tue May 17, 2016 8:26 pm
- Forum: Suzuki MightyBoy
- Topic: Ignition stock 3 terminal to modern 2 terminal
- Replies: 2
- Views: 732
Re: Ignition stock 3 terminal to modern 2 terminal
Thanks for that info
i have a .8ohm resistor from the previous owner's setup but it began to sputter then backfire when throttle was applied so i parted out my other MB (With 3 terminal coil) and runs perfect. so im not sure whats wrong there with the 2 terminal setup
i have a .8ohm resistor from the previous owner's setup but it began to sputter then backfire when throttle was applied so i parted out my other MB (With 3 terminal coil) and runs perfect. so im not sure whats wrong there with the 2 terminal setup
- Mon May 16, 2016 8:26 pm
- Forum: Suzuki MightyBoy
- Topic: Ignition stock 3 terminal to modern 2 terminal
- Replies: 2
- Views: 732
Ignition stock 3 terminal to modern 2 terminal
Hi all, i am wondering if it is possible to make the mighty boy from its stock 3 terminal ignition coil and put a stronger coil on being a 2 terminal. is there a way to convert this?
Thanks
Thanks
- Fri May 13, 2016 11:01 am
- Forum: Suzuki MightyBoy
- Topic: Gearboxs that fit an F8b motor
- Replies: 1
- Views: 588
Gearboxs that fit an F8b motor
Hi all.
just in case the repair of my current f8b manual gearbox does not go well i am wondering if there is any other 5 speed gearbox that will bolt directly into the engine and into the MightyBoy's chassis without or minimal modification?
just in case the repair of my current f8b manual gearbox does not go well i am wondering if there is any other 5 speed gearbox that will bolt directly into the engine and into the MightyBoy's chassis without or minimal modification?