if we were to collectively develop a car, youd have the first 1 engineered and have the plans. after that they would just get sold following the same plans so the engineering would already be done. so it would be similar to getting a factory5 kit. for it to make sense, it would need to appeal to any...

was thinking of a post brayden made (cant find it now) where the amount of mighty boys is getting less and the amount of traffic on this forum is getting less because of that. with the wealth of knowledge and experience on here, surely we could make a new "mighty boy" ? make up some chassi...

via jamesfromperth
hes a mechanical engineer, this thing is wicked fast and i would say its actually dangerous.
if u were to give it to a P plater for a day they would not come back alive

does anyone know what the resistance or voltage range is for the temperature sender unit? i want to hook it up to my little electric car but the motor doesnt get as hot, i can put in a voltage divider to get the resistance to scale properly but if it would be easier if someone had the information al...

hello i dont come here anywhere near as much as i used to... that said, i search this forum pretty regularly for information and can almost always find what im looking for to be asked and answered :) i would repeat what everyone else has said, that for technical information you just cant beat it. bu...

i was just curious, i saw one of those "jacks" that lift your car and is a balloon type job that runs off the exhaust, that made me think of it

how do they not get blocked up with all the crap coming through the exhaust? i would think the turbine blades would get absolutely covered in crap and need a good clean every now and then... while im at it, how do the cylinders in an engine not get covered in all that crap, do the rings scrape it al...

anyone ever had it try to earth through the handbrake cable???? wtf??

i have a workshop manual in pdf form (if anyone needs or brayden wants to add to the site, sk410) for the carry and yet i still cant find where the fuel connects to the carby, the manual describes a place that just doesnt exist on mine, anyone got a pic of where the fuel from the pump goes to the ca...

thanks for that, managed to get it in
anyone have a wiring diagram? just need it for the motor, everything else is pretty good for the most part, done a lot of searching but google only gives me samurais, are they the same?

ok so the whole lot is ready to go in, problem is trying to get it in, we r thinking to take the crossmember off, bolt the engine and mounts to that and then push it back up. the engine leans heaps to the side though, going by the gearbox. anyone got any hints or tips to make this easier or smoother...

ok so dads putting the engine together now and wants to know if its normal that the intake manifold faces down and the carby and dizzy also face downwards? if the intake faces upwards then it doesnt line up properly and would be sticking in the air heaps but still it goes against his gut so just wan...

thankyou for that but i was hoping for a downloadable version dont mind paying for it
will keep searching

ok so rebuilding the engine in the carry, got the rebuild kit already (thanks norm :) ) and am now trying to find a manual for it. iv spent a bit of time searching with no luck, but have found that the sj410 has the f10a motor aswell and have been trying to find a manual for that aswell. if anyone k...

iv just bought a 1987 carry ute with the engine pulled apart and in the tray. i wanted to know about big ends and main bearings, i want to rebuild the engine and the only thing they have written on them are D7F A and D7C D and i wanted to know if these are standard. also want to get new pistons, the...