Driving Lights

Chat about anything and everything.
Post Reply
User avatar
Tez
Posts: 1176
Joined: Wed Sep 03, 2008 9:38 pm
Location: Croydon, Vic

Hi Guys.
Just wondering how people have wired up driving lights. The system is negatively switched, so the wiring is all live to the combination switch where selecting High-beam completes the circuit to Earth and thus illuminates the High Beam... So tapping off the High-beam circuit results in a non-switchable driving light, because it will be positively energised prior to the comb. switch, and after that is just Earth...
Can't see how to wire the driving lights to dip when High-beam is dipped to low...
Tez
So the adventure continues...
playwme
Posts: 41
Joined: Fri Jan 28, 2011 8:53 pm

You can run the switching side of the relay from either negative or positive. Just choose the switching wire for the lights and then run the other as a constant.
User avatar
rf4burns
Posts: 162
Joined: Fri Sep 03, 2010 7:26 pm
Location: Central QLD

Hope this is clear Tez
spotties.jpg
Get with it ,Get over it ,Get on with it .....OR LEAVE
Post Reply