Sold

[holk]

Kei Spec. PM sent

[kei_spec_rsr]

i have attached some of the requested pics, more to come

[kei_spec_rsr]

[gazuga]

heidi just showed up with the bars, cheers mate.

she accidentally handed over too much money and kei_spec rang her to come back for it. much respect goes his way

[kei_spec_rsr]

Prices updated, will now separate engine and box

[mini_kompressor]

Fitted the steering wheel today aty lunch, looks great, cheers Mark

[Jermaine]

are they 4wd box's or just front wheel drive?

[kei_spec_rsr]

The boxes are f6a FWD, i have modified a alto shifter to fit one of them so whoever buys the first box gets the shifter setup and i will throw in a nearly new clutch cable and the starter motor to suit.

[Jermaine]

so anyone know if it would bolt to an F8b? i think it will just wantin to confirm

[Billie]

Going by what i read yes with custom shafts, gearbox mount, linkages, f6a flywheel and clutch.

[kei_spec_rsr]

the shafts have female inners, my custom shafts are the same length as 87 alto so if alto shafts fit a mb???,then my shafts will fit

can supply flywheel and clutch to suit for $50

[kei_spec_rsr]

UPDATE2X tiny tdo4 turbos off mitsubishi gto 3000gt (probably good for 800cc-1.5ltr engine??) 3 bolt turbine housing flange, dump pipe included.
$175 each

Chevoit 14"x6" rims with 175/65/14+ 185/65/14 tyres 4x114.3 stud pattern $180 set.

[JohnnyB]

PM sent

[ike849]

what is the the bolt spacing on the exhaust flange on the td03's????

Also i'm assuming they are the 9b's not the 13g's???

[kei_spec_rsr]

dont know what size exhaust housing, looks pretty small. bolt spacing is uneven 52mm,62mm,65mm. compressor housing inlet 35mm