Has anyone put f8b pistons in a f5a block or know if this has been done before?
or are there any other pistons that fit in a f5a block
f5a -f8 pistons
Most blocks can be bored out a millimeter or two max, I'm not sure about seven!
F8B EFI turbo - Three pots and a snail.
As per BUSBOY a 125cc suzuki motorcycle engine is about 62mm bore you can get these from china for about $20-$40 each with rings ; i dont know the other dimensions which would need to be checked (pin diameter, pin center to top of piston etc...see link below for an exmaple that has dimensions) but this maybe an option
http://www.aliexpress.com/item/Aluminum ... 57822.html
http://www.aliexpress.com/item/Aluminum ... 57822.html
Get with it ,Get over it ,Get on with it .....OR LEAVE