Team MightyBoy

Posted: **Sun Apr 16, 2006 10:00 pm**

hey

wanna know what's involved in making a (decent) adaptor plate for my dual throat webber. for the people that have put on webber's, where did u get the adapter plate made up. did u go to an engineer to get it done properly or just whip one up?

thanks,

jono

Posted: **Mon Apr 17, 2006 1:31 pm**

I bought a Datsun Weber adapter plate by Redline.

Posted: **Mon Apr 17, 2006 10:09 pm**

oh okay, that was for a 32/36 though wasn;t it? will i have trouble with the dual throats going into a single hole, like needing a funnel shaped adaptor plate? don't suppose anybody would know what adaptor plate i could get for mine, the 30DIC?

thanks,

jono

Posted: **Mon Apr 17, 2006 10:18 pm**

My weber was dual throat, and the adapter plate was a funnel of sorts.

Posted: **Mon Apr 17, 2006 11:24 pm**

okay, cool. will see what i can find with redline.

thanks,
jono

Posted: **Wed Dec 06, 2006 7:29 pm**

Hey guys.
I know Jono has fitted one of these weber carbs. I think he mentioned he drilled out the base of the carb to make it fit?

I haven't done any running around for an adapter yet, but was wondering if the base hole spacing would be the same for a 30dic as they are for other smaller webers?

Does anyone out there maybe have the base dimensions of a 32/36 or something like it?

Posted: **Wed Dec 06, 2006 11:24 pm**

I got a Weber 34admic it came off a XE Falcon.
would this be any good for the F8? with rejetting maybe? What jets?

Posted: **Wed Dec 06, 2006 11:38 pm**

Weber off a 4L falcon? Don't think you'd get close to tuning it for an F8B!

Posted: **Thu Dec 07, 2006 1:21 am**

They run them in geminis.
Anyone got a good 32/36 to swap?

Posted: **Thu Dec 07, 2006 1:22 am**

Probablybe a bit breathless tho.

Posted: **Thu Dec 07, 2006 3:49 pm**

Hello... Help needed

If I were to buy another weber for my car, and I probably will for my 'good' engine, I'd be seriously looking at a weber 28/36 (or 34?) that came off performance cortinas and the like.

Posted: **Thu Dec 07, 2006 6:57 pm**

Any of the DGV Webers use the same base plate Fritz. All you need is an off-the-shelf Redline Datsun adapter plate.

Posted: **Thu Dec 07, 2006 9:06 pm**

Excellent!!!
Any particular type of datsun I should be looking for, or are they all the same?

Thanks.

Posted: **Thu Dec 07, 2006 9:23 pm**

1000, 1200, 1600 - they should all be the same.

Posted: **Fri Jan 19, 2007 4:15 pm**

I've just emailed redline products to find out about the adaptor & will post details when I receive them.

Brayden, could you tell me if the adaptor that you used rotated the carb through 90 degrees? I've not seen one, but it seems like that is the most likely way of doing this.

One of the pics in your album suggests otherwise though.