MightyBoy tech questions and answers.
fritz
Posts: 711 Joined: Fri Apr 16, 2004 11:21 am
Location: Perth WA
Thu Aug 12, 2004 2:16 pm
Is it possible to have the rear drums machined? - or are they too thin like the front discs?
Ta
Colin
Posts: 1145 Joined: Tue Apr 13, 2004 8:46 am
Location: South Coast (NSW)
Thu Aug 12, 2004 7:28 pm
they can be machined but be careful if you increase the diameter too much you will end up with a low pedal,unless you fit oversized shoes
MORE BEER!
Josh
Posts: 1263 Joined: Tue Apr 13, 2004 2:22 am
Location: Canberra ACT
Contact:
Thu Aug 12, 2004 8:00 pm
Guess we'd better get oversized shoes when we get around to doing my rear brakes... I'm pretty sure they've been machined out prior to disassembly by the old brake shoes!
[url=http://www.tamon.org/?page=owners&id=10][img]http://www.tamon.org/forum/images/ute_specs.gif[/img][/url]
fritz
Posts: 711 Joined: Fri Apr 16, 2004 11:21 am
Location: Perth WA
Thu Aug 12, 2004 8:04 pm
OK
Sounds bad for mine then. - There's already quite a lip between the edge & where the shoes have ground away.
TA