M10 wheel nuts
Posted: Sun Mar 02, 2008 12:47 am
hey guys, this is my first post, and I know this subject has been thrown around on here but I just need some clarification
i dont own a mightyboy, I have a ML Barina, but it seems that this site has more about the M10 studs issue than the Swift sites.
I found the NICE products nut (NN560C), and it appears to have more of a larger taper than the stockie nuts that are on the MB's and my barina, so I am wondering if these would be alright to bolt on a set of 14" CSA mags, which came off of a '91 lancer (therefore being made for a 12mm stud, and they look like they use the stock lancer nut)
the wheel should centre itself as the nuts are tightened, and if the nuts have more of a taper than the suzuki stockie nuts they should be enough.
I just dont want to spend $100 plus on wheel nuts, and it seems changing studs would cost that much anyway.
I dont really want to take the drums and rotors off to drill out the holes and whack in 12mm studs.
Its just that my budget is severely limited.
Basically, who has bolted on a set of mags, with tapered nut seats, using the NN560C nuts successfully, and can I get a picture with the nut off and the nut on? And one last thing, how much were the nuts?
Sorry about all the questions, just want to clear it up for myself.
Thanks
i dont own a mightyboy, I have a ML Barina, but it seems that this site has more about the M10 studs issue than the Swift sites.
I found the NICE products nut (NN560C), and it appears to have more of a larger taper than the stockie nuts that are on the MB's and my barina, so I am wondering if these would be alright to bolt on a set of 14" CSA mags, which came off of a '91 lancer (therefore being made for a 12mm stud, and they look like they use the stock lancer nut)
the wheel should centre itself as the nuts are tightened, and if the nuts have more of a taper than the suzuki stockie nuts they should be enough.
I just dont want to spend $100 plus on wheel nuts, and it seems changing studs would cost that much anyway.
I dont really want to take the drums and rotors off to drill out the holes and whack in 12mm studs.
Its just that my budget is severely limited.
Basically, who has bolted on a set of mags, with tapered nut seats, using the NN560C nuts successfully, and can I get a picture with the nut off and the nut on? And one last thing, how much were the nuts?
Sorry about all the questions, just want to clear it up for myself.
Thanks