Alto RSR 04/89 - The Registered One / The Black One

[Goofy[HSK]]

Yeah, inquiring about that as well; I've got one but could do with 2 more

Looking at some non-suzuki timing sets too, and I'll keep my genuine one for the better car.

JP Auctions have Timing Belt, Water Pump and Tensioner for $100!
A genuine pump by itself is that

Oh, radiators are made, should be posted to me next week

[benny]

Is there any spares u don't have?? Lol, that was quick for the radiators mate, was expecting another month or so

[Goofy[HSK]]

Radiators should be with me by the end of week (tomorrow if couriers get off their butt), will check them out and make brackets if needed.

Wheels finally landed in Sydney

Ordered 2 more gasket kits (now 3 total)

[benny]

Good stuff mate, where do u get your gaskets from? I got one complete set but will be using that soon for the f6a, would like to have some on back up if I need some before the f6a gets done

[Goofy[HSK]]

Good stuff mate, where do u get your gaskets from? I got one complete set but will be using that soon for the f6a, would like to have some on back up if I need some before the f6a gets done

Through Streeter, think he just uses a Suzuki dealer near him

Engine Gasket Set (11401-70867) - 15,330yen (pp)

My first set I paid $200 (pp) with Capppa Sport

[benny]

I haven't used streeter yet, but should, I paid over 200 for mine, thanks mate

[Goofy[HSK]]

Going to put a stereo in this one now since I got a 2din unit on sale,

Anyone familiar with factory front speakers on these?
There's grills on the dash, but mounting points are odd
- found some parts numbers for a bracket for the later dashes, perhaps they might be interchangable

[Goofy[HSK]]

Parts arrived - https://www.hillsidekonnection.com/117-pppparts

Still intending to put a stereo in, bought some 6x9s and 4" at JB's sale.
Rear cargo floor is getting built.

Still would like to put front speakers in dash, but not sure
Pics of the 'grills' -  http://s86.photobucket.com/user/Goofy-H ... /Alto/Dash


There are front speaker part numbers in the EPC, so they must have gone somewhere  :NFI:
http://suzuki.epcdata.ru/alto/32_cm11v/electric/391/

[benny]

I have my dash out at the moment mate if u want any pics or want me to check anything for u

[Goofy[HSK]]

I have my dash out at the moment mate if u want any pics or want me to check anything for u

If there is anything extra in those locations in yours, snap a few pics

[benny]

Will have a look for u mate and let u know

[Goofy[HSK]]

New deck with the Nitto 2din mounting kit

Bracket uses existing holes in rear of console


Been working on the rear setup, using frame and carpet made by previous owner.

Middle section will lift up for storage, access to the bolts holding it in.
Staples on right will be removed - just used for securing the carpet during gluing.

Grills are from Bunnings


Expensive :\



6x9s mount on a lower piece of MDF

[Goofy[HSK]]

In, will cleanup after



Room in first gear

[benny]

Looks awesome mate, I haven't forgotten about checking the front ones out for u, have been away with work but heading home late tonight, so will suss it out for u tomorrow, sorry for the delay mate

[benny]

Ok goofy, I have front speakers in mine, they screw into the back of those vent bits, into the dash itself, look about 4 inch mate, do u want me get a pic for u?