Hi, would anybody have a pattern for the floor and back panel of a mighty boy tray.
Would like to get one made up. Would be easier if I could source a pattern
Pattern for checker plate tray inserts
1 piece A0 cardboard at any stationary supplies or newsagent will suffice for both.
Cut the overall dimensions first (width x depth) and then round corners and wheel arches.
Make sure you drill few holes in the MB tray for drainage, otherwise it will rot in no time.
10 minutes job and less than $5.00
Cut the overall dimensions first (width x depth) and then round corners and wheel arches.
Make sure you drill few holes in the MB tray for drainage, otherwise it will rot in no time.
10 minutes job and less than $5.00
[img]http://www.tamon.org/gallery/d/11796-1/holk3-1.jpg[/img]