Page 1 of 1

Solution: Lowered springs for Super Carry SK410

Posted: Mon Oct 07, 2013 7:50 pm
by Brayden
I've been driving around for 12 months or more with lowering blocks in the rear of my Super Carry but the front still stuck up at standard height. Today I decided to go through my shelf of coil springs and see if I could find something to sort that problem out. After a bit of trial and error I discovered that the same springs most MightyBoy owners end up using in the front of their utes are also suitable for a Super Carry:

King Springs KSFL12 - Suzuki Swift MK1 (1986-88)

These springs give roughly 2" drop. They're possibly a little bit on the soft side, but as an off-the-shelf solution I would recommend them. If you were keen enough then King Springs will make custom variations (for an additional cost), in which case I'd say a strength increase of 50-100 pounds would be an improvement.

Re: Solution: Lowered springs for Super Carry SK410

Posted: Tue Nov 05, 2013 10:15 am
by BALLSY
What lowering blocks did you use in the rear?

Re: Solution: Lowered springs for Super Carry SK410

Posted: Tue Nov 05, 2013 3:49 pm
by TurboKat
Datsun 1200 ute lowering blocks fit perfect in Carrys.

Re: Solution: Lowered springs for Super Carry SK410

Posted: Tue Nov 05, 2013 5:30 pm
by BALLSY
Thanks for that mate

Re: Solution: Lowered springs for Super Carry SK410

Posted: Tue Jul 07, 2015 9:43 pm
by murryinc
I just installed these tonight. Didnt lower much out the box maybe 10mm cut 15 mins later one coil gone and its sitting now 50 mm lower. Blocks will be going in rear then work equip 01s are going on. I need flares tho damm 13x7 wheels

Re: Solution: Lowered springs for Super Carry SK410

Posted: Wed Jul 08, 2015 12:18 am
by Brayden
murryinc wrote:Didnt lower much out the box maybe 10mm
Springs need time to settle before giving you the final ride height.
Also I didn't test them in an ST90 so I can't say what the result would be.

Re: Solution: Lowered springs for Super Carry SK410

Posted: Wed Jul 08, 2015 7:03 pm
by murryinc
Im happy with them man thanks for recommendation. They wouldnt have Dr opped 50 plus mm tho it was 590mm to wheel arch with either set of springs thats why they got grinder treatment

Re: Solution: Lowered springs for Super Carry SK410

Posted: Sat Jul 11, 2015 12:01 am
by Brayden
Sounds like the ST90 struts must be a bit shorter between the spring collars than an SK410.

Re: Solution: Lowered springs for Super Carry SK410

Posted: Mon Jul 27, 2015 3:02 pm
by murryinc
Dumped