Solution: Lowered springs for Super Carry SK410
Posted: Mon Oct 07, 2013 7:50 pm
I've been driving around for 12 months or more with lowering blocks in the rear of my Super Carry but the front still stuck up at standard height. Today I decided to go through my shelf of coil springs and see if I could find something to sort that problem out. After a bit of trial and error I discovered that the same springs most MightyBoy owners end up using in the front of their utes are also suitable for a Super Carry:
King Springs KSFL12 - Suzuki Swift MK1 (1986-88)
These springs give roughly 2" drop. They're possibly a little bit on the soft side, but as an off-the-shelf solution I would recommend them. If you were keen enough then King Springs will make custom variations (for an additional cost), in which case I'd say a strength increase of 50-100 pounds would be an improvement.
King Springs KSFL12 - Suzuki Swift MK1 (1986-88)
These springs give roughly 2" drop. They're possibly a little bit on the soft side, but as an off-the-shelf solution I would recommend them. If you were keen enough then King Springs will make custom variations (for an additional cost), in which case I'd say a strength increase of 50-100 pounds would be an improvement.