F10A engine + gearbox
Posted: Tue Feb 03, 2015 5:03 pm
hi everyone
i've had an F10A engine sitting under my house for a while now. it was left over from my swap.
from what i remember the bottom end has had basically a full rebuild (bearings, piston ringss, pistons etc) but the top end needs stem seals done. i found a working engine so i just swapped it rather then doing seals
council clean up is coming in a fortnight and if no takers it'll be going out for scrap.
there's also a 4 speed gearbox attached to it
make an offer
comes as is with what ever is attached to it
located in morisset NSW 2264
i've had an F10A engine sitting under my house for a while now. it was left over from my swap.
from what i remember the bottom end has had basically a full rebuild (bearings, piston ringss, pistons etc) but the top end needs stem seals done. i found a working engine so i just swapped it rather then doing seals
council clean up is coming in a fortnight and if no takers it'll be going out for scrap.
there's also a 4 speed gearbox attached to it
make an offer
comes as is with what ever is attached to it
located in morisset NSW 2264