Page 1 of 1
F5a efi turbo! Need ecu and wireing harness!!
Posted: Mon Sep 12, 2016 1:22 pm
by Kaleb1522
New to the mighty boys.
Just got a project mighty boy with a rebuilt f5a and new turbo.
Im needing a ecu and a wireing harness to sute.
If anyone can point me in the right derection that would be awsome!
Kaleb.
Re: F5a efi turbo! Need ecu and wireing harness!!
Posted: Mon Sep 12, 2016 8:37 pm
by Brayden
I don't like your chances of finding anything locally, which leaves the option of importing from Japan. There's an
ECU on Yahoo Auctions Japan for $200, which will set you back about $360 delivered. After that you still have to figure out how it wires up without instructions, and you're stuck with factory limits on boost and speed.
If I was in your position I'd go for an aftermarket ECU. Even a budget unit will be better than factory, and easier to install with instructions.
Re: F5a efi turbo! Need ecu and wireing harness!!
Posted: Mon Sep 12, 2016 9:48 pm
by Kaleb1522
So today i have figured out that the epi intake and turbo is off a f6a motor.
Is that a issue? Or will it work? As he hasnt had it running since rebuild.
Even if i can get a f6a ecu and wireing harness can i just get the ecu remaped?
Thanks
kaleb.
Re: F5a efi turbo! Need ecu and wireing harness!!
Posted: Mon Sep 12, 2016 11:22 pm
by Brayden
The F6A manifold isn't an issue. It will work just fine. Although using it will rely on having the F6A electronic distributor (the standard dissy uses points).
FYI: Suzuki factory ECU's can't be remapped.
Based on the little bit of info you've given, it sounds like you're starting out from scratch with your setup.
If you want a breakdown of a similar build (F8B instead of F5A), here's a quick summary that might help:
http://www.teammightyboy.com/forum/view ... f=1&t=2931