Team MightyBoy

Posted: **Fri Sep 23, 2005 4:23 pm**

I'm with Col on this one... I had a pod type filter on mine and all it did was made it sound better... get cold air from the front...

Posted: **Fri Sep 23, 2005 4:31 pm**

eh. how do u fit one. cuz i went to super cheap and apparently u need a certain pod for certain vehicles? and some certain fits of some type i dunno i wasnt really paying attention.

Posted: **Fri Sep 23, 2005 9:19 pm**

Col', about the ducting an intake to the front grille should it be rubber piping or stainless steel? And a Conical K&N should do the job right???

Posted: **Fri Sep 23, 2005 10:21 pm**

i have the ducting here, bought it with good intentions, never used it

Posted: **Fri Sep 23, 2005 10:23 pm**

Ok but i need something here in India!!!!!

What type is it.....Rubber or Stainless Steel??

Posted: **Sat Sep 24, 2005 8:54 am**

stainless will obsorb heat easier defeeting the pourpose.plastic or rubber is ok

Posted: **Sat Sep 24, 2005 11:54 am**

I found the pod's with the 3" fitting on them fit straight over the carby. The strandard pod looks like this:
...///\\\
..////\\\\
./////\\\\\
//////\\\\\\
...l____l
This one won't fit straight onto the carby due to the bonnet...
But I managed to find on that was shaped like this:
. /''''''''''''''''\
/________\
.....l____l
I payed about 30bucks for it, it was one of those cheapo imitation K&N lookalikes...

Did the job though, I'll have a look around and see if I can find a photo of it...

Posted: **Sat Sep 24, 2005 11:12 pm**

This is what i initially wanted, but as Colin spoke about the hot air in the engine bay not doing much for the freeflow intake i think im a gonna figure out some place i can take the plumbing to so that the carby is fed with fresh cold air, or if i got a hood scoop just above the carby then the contraption will work, wont it??

The contraption!!!

Team MightyBoy

Can somebody tell me..