Page 1 of 1
Weber Carb to suit F5a ?
Posted: Thu Feb 15, 2007 5:26 pm
by Alto Boy
Guys, is there a small webber carby to suit the F5a engine and is there an adaptor plate as well ?
If so, what is the model numbers for both and where can I get one and approximately how much.
Thanx.............Greg.
Posted: Fri Feb 16, 2007 12:24 pm
by fritz
Quite possibly. Your $$$$ would be far better spent for a f8b conversion though. They're more powerfull AND more economical.
Any weber that would run good on a f5a would probably not make a good choice for the f8b, so if you did eventually upgrade to the f8 you'd have to fork out more $$$ for another carb. ;-(
Posted: Sun Feb 18, 2007 10:34 pm
by Joel
a little 30DIC weber could probably be jetted to suit
finding one might be abit of a challenge tho
Posted: Mon Feb 19, 2007 2:53 pm
by Alto Boy
Thanks Joel.....and Fritz I've already spent over $2000 on this engine, so an upgrade is out of the question.....just a wisker more get up and go will be sufficient.
If I can find one, is there an adaptor plate to suit ?
Thanks..............Greg.