Team MightyBoy

hi , where can i buy the plastic mould ( malo strip ) for the windsreen rubber for a Hatch ? or what do you use ? thanks qbucket

if by malo strip u mean the black rubber seal holding the windscreen in, then pretty sure obrien glass or similar will do it for you

and if by malo strip u mean the silver metal taping that goes on the inside of the black rubber seal, then u can get them at SCA or i bought some at the Toowooba Swap Meet!!! what a day... i saw a suzuki hatch badge!!!!!!!! yer anywayz it wont be for a hatch exactly but i think the one i got was for a torana but it probs doesnt matter too much

and if u mean something else then i wouldnt have a clue

hope this helps

hi , yes the "malo strip" is the chrome plastic strip in the midle of the windscreen rubber ( on the out side )

the Torana section is not exactly the same , but may have to do ? would like the rite section so it fits the metal corner moulds . will try your contact.

thanks qbucket

doubt you will find the corner strips, might have to make them up yourself, the stuff i bought was only the straight edge. oh and i think u need somewhere near 4m of the stufff to do the whole screen

hi , i do have the corner moulds . i found some samples i got of some windscreen fitters , one is a torana ? i think its a bit wide ? but the other one may do , slightly narower .
thanks qbucket