Team MightyBoy

Due to fire in the engine bay, I am looking for a MB loom to put the HOLK back on the road..
I am in Melbourne but prepared to pay postage and reasonable cost. PM details .

Thanks

Paride

Sorry I can not help. But being as you have been involved somewhat involved with wiring, could you advisee of something to do with my wiring.
I removed the guage cluster from my Mighty Boy about 2 years ago for the rebuild. I have now now just refitted it and just besides the round multiple connector wires that connect to the back of the guage cluster is a single male spade fitting protruding. I have a two terminal connector that is in that immediate area but can not see which of the two wires should connect to this single male spade connector. are you able to advise me which colour wire should be connected to this. ????
Any help would be appreciated

Hi SpankyGirl,
Not sure if I will be able to help you, as I fitted an aftermarket digital cluster, cutting all the wires to the original tacho. I will check this week end if I can see what was connected to what.

P

yeah i came past that to spanky girl. i just picked the closest one. id say there both constant 12v so they prob just do lights, so it wouldnt matter.

im pulling the loom out of my ute atm for him. Will i assume he only wants the engine bay part? hmmm

Mate,

I am after the complete main loom (from engine bay to inside of car). I don't need the connections to the heater, indicators switch, ignition......).

If you were only to get the engine part, you would have to cut the loom in half, which is not good for me.

Thanks

dont worry i havnt cut it. i just couldnt figure out if you did want it just throught the firewall an unplug it or you wanted all them other bits. il have it out tonight for you.