Team MightyBoy

hi all just got my mighty boy its a 2 speed auto but i need info on the box it has type d on the box i am unable to find any info anywhere on it and need to find out the vaccum line setup any info will be great thanks

This might help you:
http://www.teammightyboy.com/images/wor ... lement.pdf

thank mate that is what i needed help heaps

so the gear box still does not up shit by itself try another computer checked and replaced the vacuum lines and the switch on the peddle so dont know my next steep an idea people

When isn't it upshifting?

a) When you come to a complete stop
b) When you press the pedal to the floor at under 60kph
c) When the engine is under load on an uphill road
d) All of the above

D) All of the above

tryed

two computers
black and green vaccum thing works fine continuity when ya pull it up with vaccum gun
speed sensor at back of speedo works like it should
switch at peddle works has continuity open and close
checked shift solinoid with ohms meter and is within specs (10-16)ohm ive got 12 ohms
adjusted shift cable all is good all lines up in all (park,r,n,2,1)

so dont know the next steep

My memory of the operation of the mb auto is a bit hazy as it has been a few years since i opened one up, however, if my memory serves me correct, the auto has one band and one clutch. I think the clutch changes the gears (it actually connect or disconnects two shafts) and has a piston that activates it. This is on the end of the gearbox. If the piston sticks (or the clutch) then you will have troubles. Or if the clutch is worn out, then you'll also have troubles.

but you can put the t bar in 1 gear and while you are driveing push the t bar to drive and it goes to 2nd gear so i think the box is fine

any-one knows how much is to rebuild the 2sp auto box?..mine has just shit itself..I smell oil burn..when i shift t-bar in any gear it feels tight..its done 315000kms....................MANNY

About $700 for a box rebuild and another $300 for a new torque converter.

thanks brayden............MANNY

Hi Manny.
Ben had a job done on Louise's trans whilst he was fiddling about with the donk.
Where / What / How many $$$ I dunno.
You might PM him for some detail...