Team MightyBoy

Hey everyone,

I'm in need of a pre-EGR exhaust manifold for my F8b. Either that or a set of extractors for the moment(going down the turbo road later). Does anyone have a manifold that I can buy?

It must not have the EGR fitting on it.

I'm in Wyndham Vale, but will travel around Melb, Geelong & so on area's to get the manifold I need.

Cheers

ToranaGuy

Bump - still very much in need, or hell, even a F8b EGR carby manifold, not fussed if it's auto or manual, but it can't be cracked at all lol.

Cheers

ToranaGuy

Not too sure what the issue is but it sounds like you have an egr exhaust and a not egr inlet and are trying to match the two up. If so i have a blanked off egr bung here from that g10a that might fit.

Cheers Paul

Am I understanding all you would need is a threading bung to go in the exhaust manifold to sort the problem? If so I may be able to help

Threaded bung? I bought a bolt for mine and screwed it in, cut off the head and tack welded it in place.

Hey guys, thanks for the replies.

I require one of the following...

A NON EGR type exhaust manifold - ie no EGR hole.

OR a Bung/bolt to block it off. I don't want to weld the hole up. If anyone knows the size of the thread I could probably get a bung/bolt to plug it up.

Trouble is I think the EGR intake I have is cracked, and don't have another to just simply swap over. To change to non EGR I need to remove the EGR or block it off on the exhaust manifold too.

Cheers

ToranaGuy

Anyone know the thread profile so I can get a bung & plug my manifold?

Cheers

ToranaGuy