2 channel or 4 channel

[Kel]

ok i bought an amp n now im wondering what wiring to use with it ?? it says the main technique parameter is 1400watts (350W x 4 load 4 ohms) and bridged output power max is (700W x 2 load 4 ohms). im lookin to buy a set of splits and a sub so should the sub be a load of 4 ohms and the speakers 4 ohm each ?? running sub of bridged 1st n 2nd channels and the spilts of 3rd and 4th. what kinda gauge wiring should i be looking for ??

[CoinSlot]

4 gauge power and ground if you can. Make sure it's fused within 30cm of the battery for safety.

For the speaker wire just use whatever. 16 gauge will be fine for both sub and splits.

What products are you using? Amp/splits/sub...

[Kel]

its a mos-fet power amp Powervox i think, i need to get some more mula b4 i buy splits and a sub but ill be looking for kenwood to match my headunit but i havnt seen any kenwood splits ?? any ideas ??

[CoinSlot]

How much do you want to spend?

[Kel]

hmmm not alot as im savin up for some ink... but i cant find any in repco, autobarn, or supercheap. the only splits i can find are fusions for bout $112 or some alpines for $300 or so