simple question:
http://www.tamon.org/forum/viewtopic.php?t=2214&start=0
as seen here the alternator seems to be moved to the back and hes tried putting a single belt setup in. could you leave the alternator down in front with a dual belt setup and still have to sc in front?
annoying recurring supercharger question
There just isn't enough room for both at the front, unless you moved the alternator or charger up near the rocker cover (using a bracket like Col used on his turbo setup) and then used a remote oil filter locator.
F8B EFI turbo - Three pots and a snail.
Nope. F6A has the alternator at the back, plenty of room there.
F8B EFI turbo - Three pots and a snail.
- greenzook89
- Posts: 237
- Joined: Fri May 02, 2008 5:52 pm
- Location: Brisbane
Ok, resurrecting this thread, has anyone actually put a AMR300 on a F8B yet?
Could i get away with jetting the F8B carb or would I need a Charade Turbo Carby?
Or am I better off Just getting a F6A front cut?
I've got plans swimming for my next boy, As soon as i find one!
Could i get away with jetting the F8B carb or would I need a Charade Turbo Carby?
Or am I better off Just getting a F6A front cut?
I've got plans swimming for my next boy, As soon as i find one!
Need Paint and Panel Work Done Around Brisbane?? PM me!
No reason you couldn't jet up the standard carby, but you'd need to build a pressure box around it.
F8B EFI turbo - Three pots and a snail.
- greenzook89
- Posts: 237
- Joined: Fri May 02, 2008 5:52 pm
- Location: Brisbane
that wouldnt be a prob, might get a car first and the bits and attack it then
Need Paint and Panel Work Done Around Brisbane?? PM me!
- stevan_istheman
- Posts: 851
- Joined: Tue Nov 02, 2004 10:13 am
- Location: Sunshine Coast, Queensland
- Contact:
Is there any reason you wouldn't be able to swing the s/charger around the wrong way and mount it to the body where the washer bottle is?
I know they'll be movement because the engine is rubber mounted but i wouldn't think that would matter as everything moves from the crank pully... i mean that's where the torque is generated so (in theory) the crank should sit still and the engine should move..
Any thoughts?
I know they'll be movement because the engine is rubber mounted but i wouldn't think that would matter as everything moves from the crank pully... i mean that's where the torque is generated so (in theory) the crank should sit still and the engine should move..
Any thoughts?
BAL4 Designs
For all your mechanical design and drafting requirements.
For all your mechanical design and drafting requirements.
Which direction does the blower need to turn in relation to crankshaft?
If Stevo's idea used the blower efectively rotates in the opposite direction to the crank - problem or solution? I have no idea.
If Stevo's idea used the blower efectively rotates in the opposite direction to the crank - problem or solution? I have no idea.
So many delays to getting my MB back in order with 993cc & 5 speed transaxle... neighbor issue gone, donor shell up on rotisserie, new sheds on the way.... another project also..
The blower needs to run in the same direction as the crank, otherwise it would reverse the flow of air.
F8B EFI turbo - Three pots and a snail.
it would then be a sucker
haha


F8B EFI turbo - Three pots and a snail.