F10 manifolds

[we tha ppl]

hey guys just have a quick question. dose any one know if manifolds from a g13a will fit on a f10a? or g10b? and will a g10b fit into a carry with a f10a if so what mods would have to be done cheers

[Brayden]

- G13A/G10B manifold on F10A? No.
- G13A into a Carry? Yes but with a shitload of work. Check Nehemiah's thread about putting a G15A in.

[we tha ppl]

oh ok then dang. if was guna go throght the trobel of a motor convertion i would probuly tru and just use the motor out of a newer carry as they are already setup to run in a van.

I was going to just pm you brayden but figerd better the info be up for any one elce looking for it

[Brayden]

Good thinking.

I reckon you're right about using a G13BB as well. It is already in a van, so most of the hard work is done.

[Nehemiah]

Yep, I agree with Brayden. In hindsight that would have been a much simpler and cheaper conversion.

Have fun with it!
Sam