Does anyone know if a Swift / Cultis front cv will fit the alto?
They appear to be the same size externally including the front hubs and carriers.
My local CV shop advised there are 3 different inner spline sizes on the cv that fits onto the axle?
I found an earlier Swift but not sure if the inner spline is small enough?
I fitted new CV joint to the RSR it was the smalest size of the 3 they measure the spline by diameter in the catalogs. I think it was 18mm dia from memory. Had to cut the old one off those circlips can sure get stiuck in! I also used a rear axle bearing from a Ford cortina to replace the r/h axle support bearing because i couldnt find one the right size. The cortina bearing is only 1mm narrower so i made 1mm spacers for the outer and inner races and it worked well. The bearing size is 72x35x25 wide the cortina was 24 wide.
