Can somebody tell me..

[pullbackandgo]

I'm with Col on this one... I had a pod type filter on mine and all it did was made it sound better... get cold air from the front...

[Munchskinman]

eh. how do u fit one. cuz i went to super cheap and apparently u need a certain pod for certain vehicles? and some certain fits of some type i dunno i wasnt really paying attention.

[edmund]

Col', about the ducting an intake to the front grille should it be rubber piping or stainless steel? And a Conical K&N should do the job right???

[Eskibagh]

i have the ducting here, bought it with good intentions, never used it

[edmund]

Ok but i need something here in India!!!!!
What type is it.....Rubber or Stainless Steel??

[Colin]

stainless will obsorb heat easier defeeting the pourpose.plastic or rubber is ok

[pullbackandgo]

I found the pod's with the 3" fitting on them fit straight over the carby. The strandard pod looks like this:
...///\\\
..////\\\\
./////\\\\\
//////\\\\\\
...l____l
This one won't fit straight onto the carby due to the bonnet...
But I managed to find on that was shaped like this:
. /''''''''''''''''\
/________\
.....l____l
I payed about 30bucks for it, it was one of those cheapo imitation K&N lookalikes...

Did the job though, I'll have a look around and see if I can find a photo of it...

[edmund]

This is what i initially wanted, but as Colin spoke about the hot air in the engine bay not doing much for the freeflow intake i think im a gonna figure out some place i can take the plumbing to so that the carby is fed with fresh cold air, or if i got a hood scoop just above the carby then the contraption will work, wont it??

The contraption!!!